Fault Tracing - Asko W600 Service Manual

Product: WM 33 / 44
Date: 00-03-15
Reference: B Haglund
A The machine do not start, the timer does not proceed,
no filling, but control lamp indication
B The motor overspeeds after filling.
Connection problem ?
C Motor do not start after filling. 4-5 min later does the timer feed
to step for drainage. After drainage timer stop at “Info”.
D To short spinning time at 1000 rpm, stops, drain pump starts and after
4-5 min the motor runs according to “Loosening” cycle
Thereafter the timer proceeds to end position ( not to any control position)
(Note: Above will not occure with WM 33 set at 800 rpm or WM 44 set at 900 rpm or less)
SERVICE
WM 33 / 44.

Fault tracing

I N F O R M A T I O N
Group: 21
Number: 154
ÄO: Page: 1(2)