Toshiba 20W300PG Manual page 6

Connecting external equipment continued,
Aerial cables:
Connect the aerial to the socket on the rear of the televi-
sion. If you use a decoder and/or a media recorder it is
essential that the aerial cable is connected through the
decoder and/or through the media recorder to the television.
SCART leads:
Connect the media recorder IN/OUT socket to the televi-
sion. Connect the decoder TV socket to the television.
Connect the media recorder SAT socket to the decoder
MEDIA RECORDER socket.
Before running APS (AUTO PROGRAMMING SYSTEM) put
your decoder and media recorder to Standby.
A wide variety of external equipment can be connected
to the back of the television, therefore the relevant
owners manuals for all additional equipment must be
referred to.
NOTE: Becuse FAV CVBS and SVHS Y are connected
parallelly, the picture may blend if the two peripher-
als are used at the same time. Likewise, because
SVHS C and SCART II R are connected parallelly,
the picture may blend if the two peripherals are used
at the same time. Thus these two are not to be used
at the same time.
If connecting S-VIDEO equipment, set the INPUT for
AV-4 S. See page 18.
If the television automatically switches over to monitor
external equipment, return to normal television by pressing
the desired programme position button. To recall external
equipment, press to select between
AV-2S, AV-4, AV-4S, YPbPr, HDMI or PC RGB.
A01-ENG-(20-23W300PG)-XX790W-MB22-(1705-CT865)-(PCPIP)-10048610&11-50106343.p65
• Power off both computer and TV before making any con-
nections.
• Connect the PC cable to the PC input of your TV and to the
15-pin connector on the rear of your computer.
• Tighten the screws on the plugs until the connectors are
fastened securely.
• If you are using Windows operating system running on a
PC with a Microsoft Plug&Play compatible video card, your
system will select the appropriate timing for your monitor.
• For PC sound use the stereo jack socket located at the right
side of the tuner.
High Definition
Your TV is capable of displaying High Definition pictures
from devices such as a High Definition Satellite Receiver
or DVD Player. These devices must be connected via the
HDMI socket or YPbPr (Component) sockets. These sock-
ets can accept either 720p or 1080i signals.
PLEASE NOTE: Although this television is able to connect
to HDMI equipment, it is possible that some equipment
may not operate correctly. HDMI cables should be less
than 5m.
NOTE: It is recommended that approved HDMI cables up to
HDMI, the HDMI logo, and High Definition Multi Media Inter-
face are trade marks, or registered trade marks of HDMI
licensing, LLC.
TV, AV-1, AV-2,
English
- 7 -
7
Connecting the PC via PC input
5m long is used. If the unit has DVI output, a special
conversion cable from DVI to HDMI will be required.
11.06.2007, 16:39