HP MSM317 Installation Manual page 4

4
Faceplate and trim panel removal
To remove the faceplate, slightly push in two tabs on one side of the MSM317 body with a small
screwdriver. To remove the trim panel, pry off the trim panel with a small flat screwdriver.
Press here
to remove
the faceplate.
Punch-down block wiring
When terminating a cable run with the Punch-down block, always use solid conductor cables.
Stranded cables may not make good connections. To ensure good connections, install cables
into the individual Punch-down connectors using a 110-style tool.
CAUTION: Do not connect both the Punch-down block and the Uplink port to a network. Only
one connection can be used at a time.
© Copyright 2009 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice.
MSM317 Access Device Installation Guide
(BS 4662 version shown.)
Use a screwdriver to
pry off trim panel here.
5900-0236