HP MSM317 Installation Manual page 3

MSM317 Access Device Installation Guide
Installation procedure
A. Attach the faceplate
Place the appropriate faceplate (NEMA-WD6 for US or BS 4662 for international) over the
front of the MSM317 body and press firmly to snap it into place.
B. Prepare the electrical outlet box
The MSM317 requires a single-gang electrical outlet box mounted in a wall cavity. The US version
requires a box conforming to NEMA-WD6, with a minimum depth of 1.4 inches. The International
version requires a box conforming to BS 4662, with a minimum depth of 35mm.
1. Install an appropriate electrical outlet box. Or if using an existing electrical outlet box,
disconnect and remove any existing equipment.
2. Run the required cables through the bottom of the electrical outlet box allowing sufficient
slack for the cables to reach the not-yet installed MSM317.
C. Connect the cables
1. Connect an Ethernet cable to the
Uplink port either via the RJ-45
connector or the Punch-down
block. Do not connect to both.
(See Punch-down block wiring on
page 4 for wiring details.)
2. If required, connect the cable
providing support for pass-through
devices to the Pass Through port.
D. Mount the MSM317
1. Attach the MSM317 to the
electrical outlet box using the
supplied mounting screws.
2. Place the appropriate trim panel
(US or International) over the front
of the MSM317 body and press
firmly to snap it into place.
E. Configure the MSM317
For details, see the MSM317 Access
Device Installation and Getting
Started Guide.
3