Table of Contents
Advertisement
M3588
4.1 Disassembly Introduction
The M3588 is held together by 5 screws as other Modulus products,1 of these screws is placed beneath
the IMEI label, and 2 of these are placed below the Aux RF connector rubber cover. Care should be
taken whilst removing the display flex cable as this can be torn or broken without too much stress
being applied.
Ensure that a properly grounded high impedance conductive wrist strap is used whilst performing any
tasks during the disassembly and assembly of the unit
Avoid stressing the plastics in any way to avoid damage to either the plastics or internal components.
Many of the intergrated devices used in this equipment are vulnerable to damage from
electro-static charges. Ensure that adequate static protection is in place when handling,
shipping and servicing the internal components of this equipment.
4.2
Recommended Tools
The following tools are recommended for use during the assembly / disassembly of the M3588.
• Anti-static Mat Kit - 0180386A82, includes:
Antistatic mat 66-80387A95
Ground Cord 66-80334B36
Wrist Band 42-80385A59
• Plastic Bladed Tool SLN7223A
• T7 Torx Driver
4.3
Disassembly Procedure
The following set of diagrams will demonstrate the correct sequence and action required to disassemble
the M3588
The use of the exploded diagram on page 18 may be of some assistance for part recognition.
4.4
Assembly Procedure
Once the unit is disassembled and the repair is carried out, the unit must then be reassembled, this is
carried out in the exact reverse order as the disassembly.
14
of 45
!! CAUTION !!
European Customer Services
Advertisement
Table of Contents
