Package Contents - DeWalt DCS374 User Manual

Battery Pack
BATTERY TYPE
The DCS374 operates on an 18V XR Li-Ion battery
pack.
The DCB180, DCB181, DCB182, DCB183,
DCB184 and DCB185 battery packs may be used.
Refer to Technical Data for more information.
Storage Recommendations
1. The best storage place is one that is cool and
dry away from direct sunlight and excess heat
or cold. For optimum battery performance and
life, store battery packs at room temperature
when not in use.
2. For long storage, it is recommended to store a
fully charged battery pack in a cool, dry place
out of the charger for optimal results.
NOTE: Battery packs should not be stored
completely depleted of charge. The battery pack will
need to be recharged before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack show
the following pictographs:
Read instruction manual before use.
See Technical Data for charging time.
Battery charging.
Battery charged.
Battery defective.
Hot/cold pack delay.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced
immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care
for the environment.
Charge D WALT battery packs only with
e
designated D
battery packs other than the designated
D WALT batteries with a D
e
charger may make them burst or lead to
other dangerous situations.
Do not incinerate the battery pack.

Package Contents

The package contains:
1 Cordless Band saw
2 Li-Ion battery packs (M2 models)
1 Kitbox
1 Charger
1 Instruction manual
NOTE: Battery packs, chargers and kitboxes are
not included with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fig. 1, 4)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Multi-position bail handle
b. Lock-off button
c. Trigger switch
d. Main handle
e. Work stop (Fig. 1, 4)
f. Guide rollers (Fig. 4)
g. Adjustment locking nut
h. Adjustment screw
i. Blade tension lever
j. Hex wrench
k. Speed wheel
ENGLISH
WALT chargers. Charging
e
WALT
e
11