Switching On; Speed Selection - DeWalt DCE100 Instruction Manual

Switching On (Fig. 2, 8, 9)
CAUTION:
Do not point unit discharge at self or
bystanders.
CAUTION:
Always wear safety glasses and hearing
protection. Wear a filter mask if the operation is dusty. Use of gloves,
long pants and substantial footwear is recommended. Keep long hair
and loose clothing away from openings and moving parts.
To turn the blower on, depress the variable speed trigger (C). As
trigger is pulled from min to max position (or full off to full on), the
airflow from the blower will increase from min to max. Release the
trigger fully to turn the blower off.
To lock the blower on, press the lock-on button (D) with the variable
speed trigger (C) depressed, as shown in figure 8. To turn the blower
off when using the lock-on button, pull the trigger to release the lock.
FIG. 8
• Hold the blower with both hands, as shown in figure 9, and sweep
from side to side with tube output end several inches above the
hard surface. Slowly advance, keeping the accumulated pile of
debris in front of you.
D
C
FIG. 9
Speed selection (Fig. 10)
The 3 speed toggle switch (E) sets the maximum airflow that can be
achieved when trigger is fully depressed. Push the toggle switch (E)
up to increase air flow; push it down to decrease air flow.
FIG. 10
11
E