HP PS110 Quick Start Manual page 5

HP PS110 Wireless VPN Router Quickstart
5. Ensure that the power button is not pressed in.
6.
Connect the AC/DC power adapter to the power socket on the PS110,
and then plug the AC/DC power adapter into a standard electrical wall
socket.
7.
Power on the PS110 by pressing the power button.
Initially, the PS110 LAN port LEDs turn on and off. Wait approximately
one minute until the Alert LED turns off before proceeding to the next
step.
C. Connect to the management interface and log in
Note: A factory-default PS110 is assumed.
1. In a web browser, enter the address: https://192.168.1.1.
2.
On the Login page, specify admin for both Username and Password,
and then select Login.
Note: HP recommends that you change the default password on the System >
Admin page and select Save. Passwords must be at least six characters
long and include four different characters.
3. On the License Agreement page, read the agreement and select Accept
HP End User License Agreement.
4.
A Country prompt appears. Select the country in which the PS110 is
operating, and then click Save.
Caution: To ensure compliance, you must select the correct country.
See Country of use on page 3.
The PS110 management interface home page opens.
The management interface is organized with
menus and sub-menus. Instructions for
making menu selections, such as "select LAN
> Settings" indicate that you should select the
LAN menu, and then the Settings sub-menu.
D. Run the wizard to set up the PS110
1. Select Home on the management interface menu.
5
2. Select Start to start the wizard.
3.
Either configure the system time manually by entering the date and time,
or keep the default setting of Using network time protocol (NTP). Set
the time zone for your region, and enable daylight saving, if required.
Click Next.
4.
Set the Connection Type for the WAN connection to your ISP. The
default setting is to use the DHCP protocol. If desired, enable the
Stateful Packet Inspection (SPI) Firewall option. Click Next.
Main menu
Sub-menu
5.
Configure the wireless settings:
• Select the 2.4 GHz or 5 GHz radio band for your wireless network.
• Set the radio operating mode. Select a compatibility mode if support
for older 802.11a/b/g devices is required, otherwise HP recommends
that you select 11n only.
• Set a unique SSID name for the wireless network.
Initial configuration