Operation; Attaching The Mower - FGM STM60-318 Operator's Manual

OPERATION

ATTACHING THE MOWER

Installation of mower main body
Adjust the gauge wheel to the lowest cutting height (20mm). Position the rear gauge wheel at a right angle to the
cutting direction.
1) Stop the tractor on the left side of the mower. Turn the front wheel fully to the left. Insert a block of about
50mm under the front wheel to help installation and removal of the mower.
2) Lift the lift link with the lift control lever on the tractor.
3) Stop the engine and apply the parking brake.
4) Push the mower to under the tractor, paying attention to the piping, link, etc. of the tractor.
5) Lower the lift link with the lift control lever of the tractor.
6) Fix the lift link to the mower with the pin.
CAUTION: Install or remove the
mower on a flat and clear place.
Figure 16
Figure 17 STM60-318/324
16