Care And Maintenace - Prokonian SP2315-IR-PHRM Instruction Manual

OPERATING INSTRUCTIONS
Remote Control
Note: Remote control can
only be used while the
power switch are in "I"
position.
I I
O O

CARE AND MAINTENACE

• Make sure the unit is turned OFF, unplugged and the heating elements of heater are cool whenever you are
cleaning the heater.
• Clean the metal trim using a water-dampened soft, clean cloth. DO NOT use brass polish or household cleaners
as these products will damage the metal trim.
• The motors used on the fan and the flame generator assembly are pre-lubricated for extended bearing life and
require no further lubrication. However, periodic cleaning/vacuuming of the fan/heater and air intake/output
vents is recommended.
• Any other servicing should be performed by an authorized service representative.
Standby Button
• Press Standby button to tuen on / turn off all function.
Flame Button
• This button controls the brightness of the flame effect with settings
at High, Medium and Low. When the log set is first turned on, the
flame will come on at the highest setting. Each time the Flame
button is pressed, the brightness decreases. The only way to turn off
the flame effect completely is to turn off the Power button.
Heater Button
• Pressing the Heater button to turn on or turn off the heater, when
turn on the heater each time, heater will be turn on at least one
minute, When the ambient temperature is higher than the set
temperature, heater will turn off automatically.
6