Apollo Smart Color Pro Operating Manual

Advertisement

Quick Links

APOLLO DESIGN TECHNOLOGY
4130 Fourier Drive Fort Wayne, IN 46818 USA
Phone: +01.260.497.9191 Fax: +01.260.497.9192
www.apollodesign.net
09.04.12
Operating Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Smart Color Pro and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Apollo Smart Color Pro

  • Page 1 APOLLO DESIGN TECHNOLOGY 4130 Fourier Drive Fort Wayne, IN 46818 USA Phone: +01.260.497.9191 Fax: +01.260.497.9192 www.apollodesign.net 09.04.12 Operating Manual...
  • Page 2: Table Of Contents

    • Despite the care taken for the compilation of this book, Apollo Design Technology, Inc. Loading and Unloading . . . . . . . . . . . . . . . . . .
  • Page 3: Safety Information

    Protocol Requirements DMX 512 (1990) Input Connector XLR 4-pin male (power and control protocol) PRO . Apollo is not responsible for damage or injury resulting Output Connector XLR 4-pin female (power and control protocol) from improper use of safety cables .
  • Page 4: Introduction

    Weight 5.2 lbs. / 2.36 kg. including gel and mounting tabs If the dealer is unable to satisfy your service needs, contact Apollo directly for tech- Aperture Rear: 7 1/4” (184.15mm) Front: 7 1/4” (H)x 8” (W) (184.15mm x 203.2mm) nical support .
  • Page 5: Mounting

    Pro 5 25 Specifications ] Design Fixture Compatibility Ideal with 19° ellipsoidals and 6 inch and smaller fresnels. Power Supply Compatibility Apollo Smart Power™ 75W, 200W, 400W and 600W. Back of Dimensions 10 3/4 (H) x 9 3/4” (W) x 3 1/2” (D) ®...
  • Page 6: Powering Up

    DMX. · Insert a 4 pin XLR connector into the plug on the SMART COLOR PRO marked “IN” . flash from dim to bright. · If there is a known good DMX device in the system, set Additional SMART COLOR PROs, Smart Color or Smart Move products can be ®...
  • Page 7: Addressing

    [ Gel String Information Continued ] [ Addressing ] ® · Each SMART COLOR PRO can respond to a unique start address . To change the DMX address press the SELECT, UP or DOWN button once . “Addr” will appear . Press SELECT to select the addressing mode . Pushing the UP and 24 FRAMES DOWN buttons will step through DMX addresses .
  • Page 8: Speed

    [ Reset ] · A piece of Apollo Gel Shield is installed on the back of the SMART COLOR® PRO . The shield · To set the remote reset function press the SELECT, UP or DOWN button filters out harmful ultraviolet and infrared rays that could damage the gel strings . Be sure this once .

Table of Contents