Connecting Power And Communication Cable - Samsung AM007FNTDCH Installation Manual

Connecting power and communication cable

A
How to connect your extended power cables
1. Prepare a compressor and the following tools.
Tools
Spec
Shape
2. As shown in the figure, peel off the shields from the rubber or wire of the
power cable.
- Peel off 20 mm of the wire shields of the tube installed already.
After peeling off the tube wire, you must insert a contraction tube.
For information about the power cable specifications for indoor and
CAUTION
outdoor units, refer to the installation manual.
3. Insert both sides of core wire of the power cable into the connection sleeve.
Method 1
Push the core wire into the sleeve from both sides.
Method 2
Twist the wire cores together and push it into the sleeve.
4. Using a compressor, compress the two points and flip it over and compress another two points in the same location.
- The compression dimension should be 8.0.
- After compressing it, pull both sides of the wire to make sure it is firmly pressed.
Compression
dimension
30
Crimping pliers Connection sleeve (mm)
MH-14 20xØ6.5(HxOD)
Method 1
Compress it 4 times.
Insulation tape
Width 19mm
Power cable
5 mm
Contraction tube (mm)
70xØ8.0(LxOD)
20 20
60
120
180
20
Wire tube power cable
Connection sleeve
Connection sleeve
Method 2
Compress it 4 times.
5 mm
20
(Unit: mm)