Advertisement
SOAPY WATER TEST WARNINGS & PROCEDURES
WARNINGS
Soapy Water Test MUST be performed each time
gas cylinder is connected to burner/hose or each
time it is used.
Soapy Water Test MUST be performed outdoors in
well ventilated area.
When performing Soapy Water Test keep smoker
away from open fl ames, sparks or lit cigarettes.
Smoker is designed to work with propane gas only.
Only use gas cylinders marked propane with this
unit. This product will NOT operate with natural gas.
Never use an open fl ame to test for gas leaks.
PREPARATION:
Remove any cookware from smoker.
Make sure regulator and gas cylinder valve to OFF
position.
Prepare soapy water solution: (1) part dish washing
liquid (or more if desired), (3) parts water.
Apply soapy water solution to gas cylinder valve,
regulator and hose length up to burner.
TESTING GAS VALVE：
Turn gas cylinder valve ON and watch for bubbles.
DO NOT LEAVE GAS ON MORE THAN 12
SECONDS. If bubbles appear, stop, turn gas
cylinder OFF and retighten fi tting. Repeat test.
TESTING REGULATOR AND HOSE:
AFTER gas cylinder valve has passed Soapy
Water Test, turn gas cylinder valve ON, open
regulator control valve one full turn and check for
bubbles at valve location, along full length of hose
and at burner connection. DO NOT LEAVE GAS
ON MORE THAN 12 SECONDS. If bubbles
appear, stop, turn regulator valve OFF, turn gas
cylinder OFF and retighten the connection that is
leaking gas. If hose is source of leak, STOP, do not
use unit. Hose must be replaced.
When test is complete, and there are no leaks, wait
minimum of 5 minutes for gas fumes to diminish
before lighting cooker.
Page 5
customer service 1-855-893-2227, 9:00 a.m-6:00 p.m EST, Monday-Friday.
Apply
solution to
Apply
solution to hose regulator
and
the
full
length of the hose
gas
cylinder
valve
Apply
solution underneath control
Failed
test
will
present bubbles as
panel
where burner and hose are
shown below.
connected
(Smoker shown
on back for
clarity
only)
DURING ANY PORTION OF SOAPY WATER
TEST IF BUBBLES CONTINUE TO APPEAR,
STOP, DO NOT USE UNIT. CONTACT LOCAL
PROPANE DEALER OR MANUFACTURER
CUSTOMER SERVICE 1-855-893-2227.
Note: Use 20LB (9kgs) gas cylinder that has a
protective collar with this unit. Cylinder NOT
included with this unit.
ASSEMBLY
Washer
Wing nut
customer service 1-855-893-2227, 9:00 a.m-6:00 p.m EST, Monday-Friday.
STEP 4
Mount body handle (8) to smoker body (1)
using
two 1/4-20x1/2" screws(A) and two
flat washers(F) and two 1/4-20 nuts(C).
Repeat step on the opposite side.
Note: the right body handle (8) need through
the regulator hook(H) before mounting to
smoker body(1).
STEP 5
Insert door handle (7) into smoker
door (2). Secure using
two #10-24x1/2"
screws(B) and two flat washer(F).
STEP 6
Insert temperature gauge (13) into
smoker door (2). Secure in place
with one washer and one wing nut.
Note: the temperature is supplied with
one washer and one wing nut.
Note: Be careful not to over tighten the
wing nut.
Page 10
Advertisement
