Footcontroller (Id: Core Stereo 20, 40 Only); Mp3/Line In; Emulated/Headphone Out - Blackstar CORE STEREO 10 V2 Owner's Manual

15. Footcontroller (ID:CORE STEREO 20, 40 only)
Connect a Blackstar FS-11 footcontroller (not supplied) to control your ID:CORE in
one of the following modes:
FS-11
Default Mode
Alternative Mode
In Alternative Mode (selected via INSIDER) patches will cycle on a ʻloopʼ.
e.g switching up from OD2 will move to Clean Warm.
When in Manual Mode, the effect of any footcontroller switch will depend on its last
state. Pressing Switch 1 will return the amplifier to Patch Mode. Pressing Switch 2
will toggle the effects off and on without returning to Patch Mode.

16. MP3/Line In

Connect the output of your MP3 or CD player here. Adjust the player's volume to
match that of your guitar to enable you to play along.

17. Emulated/Headphone Out

This output emulates the tonal characteristics of a guitar speaker cabinet and
provides a natural tone for connection to headphones, a recording device, PA
system or mixing desk.
To make full use of the Super Wide Stereo effects, use a 'stereo 3.5mm jack to
two mono jacks' splitter lead to feed two channels of the recording device or mixer.
Always use a good quality screened lead.
Turning the Volume knob will control the Emulated Output level.
NOTE: The Amplifer speakers will mute when a cable is connected to the Emulated
Output.
Switch 1
Toggles between 2 patches,
selectable via INSIDER
Patch down
Switch 2
Toggles all saved patch effects
on/off
Patch up
13