Region Writing - Pioneer SC-71 Service Manual

5
Precautions
Files are stored in Root of USB memory.
Files are read from Root of USB memory.
 To make operations such as moving files, be sure to assign the saved file in Root
of the USB memory.
Also please be careful not to assign *.avr in multiple numbers.
The time and date of updating for saved file is fixed to "2006/03/08 20:01."
In principle, please implement Load without making of factory default settings.
[Cautions]
You cannot use the backup function with USB memory until the BridgeCo software starts.
It takes about 35 seconds before the BridgeCo software starts.

8.3 REGION WRITING

This is the function to write Region information by using an USB Memory.
Automatic start-up is conducted with POWER ON if the Region information is not written.
This work is carried out when DISPLAY ASSY is replaced.
[Preparations]
1. Please copy the REGION File for the same model number and the point of destination with the object set to the route
directory of USB Memory.
Note: Copy only the REGION File to the USB memory. Never copy to other files.
[Precautions]
Please be sure to use the REGION File for the same model number and the point of destination with the object set.
If you make a mistake, it is impossible to rewrite. (Replacement of DISPLAY ASSY is required again)
Key operation
Plug in the AC cord.
(No Region information)
Power On (Automatically)
Start up finished
Function initial display
Connect USB
Memory.
Loading finished
correctly
Region Writing finished
[Cautions]
Writing of destination is not completed until the BridgeCo software starts.
It takes about 35 seconds before the BridgeCo software starts.
5
6
FL display
P O W E R O N
S E T R E G I O N
S C - 7 1 / C U X J
SC-71
6
7
[Procedures]
1. Connect an AC cord after replacing DISPLAY
ASSY. (Power turns ON automatically)
2. [SET REGION] is displayed several seconds after
[POWER ON] is displayed on the front panel.
(Standby status for REGION File writing)
3. Automatic writing starts when USB memory
prepared by [Preparation: 1] is inserted.
(Degree of several seconds)
4. The written model number is displayed after the
normal completion of REGION File writing.
(14 characters, maximum)
5. Pull out the AC cord.
7
8
A
B
C
D
E
F
59
8