Pioneer SC-71 Service Manual page 48

1
[2] Rear Section
Remove the Bonnet /71 by removing the 16
screws.
A
-----------------------------------------------------------------
[2-1] Rear Section
(1) Release the cables from the two PCB binders.
(2) Remove the HDMI Cable (ADX7732) by
disconnect the connector, and then connect
the another normal HDMI Cable.
Note: Don't connect the HDMI Cable provided
with the product to prevent damage to the
HDMI connector for the DIGITAL MAIN_L
ASSY. Instead, use the another normal
B
HDMI Cable to prevent a load from being
applied to the HDMI connector.
Always connect the HDMI Cable because
the iPod iPhone iPad LED blinks, which
causes a shutdown, if the power is turned
on without the cable connected.
Note on assembling
∗8: Pull the cables to the direction of the blue arrow.
Doesn't touch the cables to the Heat Sink, the
Fuse and the Bonnet /71.
C
(3) Release the cable from the two PCB binders.
(4) Cut the two Binders.
(5) Remove the HDMI Cable (ADX7732) by
disconnect the connector.
(6) Remove the 15P FFC (ADD7784) by disconnect
the two connectors.
(7) Release the Push Rivet.
(8) Disconnect the connector.
D
Notes on assembling
∗9: Twist the PCB binders around the 7P Housing
(ADX7801) and tilt in the direction of the blue
arrow, so that it don't touch to the PCB and
the Bonnet /71.
*10: Pull the 7P Housing (ADX7801) to the
direction of the blue arrow and then fix the
binder.
(9) Release the cable from the PCB binder.
E
(10) Disconnect the connector.
Note on assembling
∗11: Twist the PCB binder around the cable
(PF04PG-S20) and tilt in the direction of the
blue arrow, so that it don't touch to the
capacitors and the 5P cable.
F
48
1
2
Heat Sink
Front
4
DIGITAL MAIN_L ASSY
3
Front
∗11
PF04PG-S20
Front
SC-71
2
3
∗8
Fuse
USB RECT_SS ASSY
∗8
1
HDMI Cable
2
JA8003
HDMI USB ASSY
7P Housing
8
4
∗10
7
CN603
JA9620
3
∗9
CN2503
6
6
∗9
15P FFC
AUDIO_SS ASSY
INTERFACE_SS ASSY
∗11
10
CN7502
9
5P cable
B-DIODE_SS ASSY
3
4
HDMI Cable
5
CN7905
V-REG_SS ASSY
4