Zanussi ZRX51100WA User Manual page 18

Problem
The appliance is noisy.
The compressor operates
continuously.
There is too much frost and ice.
Water flows inside the
refrigerator.
Door is misaligned or interferes
with ventilation grill.
The temperature in the appliance
is too low/too high
18
Possible cause
The appliance is not
supported properly.
Temperature is set
incorrectly.
Many food products to be
frozen were put in at the
same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed
correctly.
The door is not closed
correctly or the gasket is
deformed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set
incorrectly.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The appliance is not levelled.
The temperature regulator is
not set correctly.
The door is not closed
correctly.
The food products'
temperature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
There is no cold air
circulation in the appliance.
Solution
Check if the appliance stands
stable.
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on the
rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Refer to "Closing the door".
Position the water drainage plug
in the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Refer to "Levelling".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products
temperature decrease to room
temperature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Make sure that there is cold air
circulation in the appliance.
www.zanussi.com