Reversing The Door Swing - GE ZDBG240 Owner's Manual

Parts included:
To reverse
the door
Tools required:
To remove the door:
Rotate the door:
The handle will be on the right side of the
door; hinges will be installed on the left
side of the case.
To reinstall the door:
1. Top left case hinge
2. Bottom left case hinge
3. Left and right side decorative hinge
cover
4. Decorative hinge screw hole cover
5. Torx ® driver bit
1. Phillips screwdriver
2. Electric drill
1. Flatten the shipping carton to use as
a pad.
2. Remove the 2 screws and the toekick.
Set aside the screws and toekick for
final installation.
3. Use the supplied Torx
drill to remove the 3 screws holding
the top case hinge. Lift off the hinge.
(Screws will be used to install the
new hinge.)
4. Lift the door off the bottom case
hinge.
5. Remove the bottom case hinge pin
and bracket.
1. Remove the door stop and cam riser
on the original bottom right side of
the door.
2. Remove the fill plug on the top right
side of the door.
3. Turn the door over and reinstall the
fill plug on the new left side.
1. Install the original door stop and cam
riser onto the bottom left side
of the door.
2. Install the new supplied bottom case
hinge pin and bracket onto bottom
left side.

Reversing the Door Swing

Install
3 Hinge
Screws
3. Place the door onto the bottom case
4. Install the supplied left-hand top case
® bit and electric
5. Select the hinge cover marked with
6. Peel backing off the tape inside the
7. Press and snap
8. Snap the screw
IMPORTANT: Check to be sure screws
are tight and that the door is straight and
does not sag. The door should swing freely.
NOTE: See Installation Instructions to
apply hinge cover and screw hole cover.
Position nameplate:
Apply the Monogram nameplate on the
door using the template included in the
installation instructions.
Beverage Center
Door Stop
and Cam Riser
hinge.
hinge with the 3 original screws.
an "L".
decorative hinge cover.
the hinge cover
into place.
hole cover into
place on the
opposite side.
Remove
Top Hinge
Hinge
Pin and
Bracket
Remove
Hinge
Install Covers
11