Removal Of Expansion Module; Connecting Console Cable To Compex Sxp2224Wm; Configure Hyper Terminal Program - Compex sxp2224wm User Manual

Chapter 4 Hardware Installation
4.3.1

Removal of Expansion Module

1.
2.
3.
4.4

Connecting Console cable to Compex SXP2224WM

Console Configuration allows you to set Compex SXP2224WM for remote terminal
as if the console terminal is directly connected to it.
The console cable is a male DB-9 connector that enables a connection to a PC or
terminal for monitoring and configuring Compex SXP2224WM. Using the supplied
RS232 console cable with a female DB-9 connector, you can easily connect it to a
terminal or PC to the console port.
4.4.1

Configure Hyper Terminal Program

After established the hardware connection, you need to set your hyper
terminal configuration as shown below:
Bits per seconds: 9600
Data Bits: 8
Parity: none
Stop bits: 1
Flow Control: none
Now, you can access to Compex SXP2224WM through console
configuration!
Power off Compex SXP2224WM and remove any cable connecting to
the module.
Loosen the captive screws which are used to secure the module and
slide the module out completely from the window.
Cover the empty expansion module window with the metal plate and
tighten it up with the screws provided.
13