Table of Contents
Advertisement
Operating Instruction
1.Speed Sensor and Display
ITEM
Operation Features
Tolerance
Digital Range
Display Switch Button
2.High /Low Speed Setting
ITEM
Operation Features
Symbols on LCD
Flicker Frequency
Speed detection by speed hall sensor from transaxle with conversion at 1821 rpm equal to
Initial setting at km/h, switch to MPH by
(1) Trigger buttons to switch from high-speed to low-speed (also from low-speed to
high-speed), then set the number of segments from 1 to 5 .The setting time will take 5
seconds for each segment.
(2) L will flash while turning at corner.
(3) As a constant speed detector to determine the signal, the speed light will flash while
travelling at constant speed.
＂L＂symbol flashing means "Turning at the corner"
www.vitamobilitywerks.com
SPECIFICATION
37 mph.
5~15% (±2%)
0~199 km/0~124 mile
SPECIFICATION
＂H＂symbol means "High Speed" –Corresponding from 1-5
＂L＂symbol means "Low Speed" – Corresponding from 1-5
1 sec
16
MODE
and
SET
buttons
Advertisement
Table of Contents
