Siemens TJ10500 User Manual page 27

Long-sleeved shirts
❏ Pull on the cuff adjusters until the arms of
the ironing dummy reach their maximum
length (longer than the shirtsleeves).Raise
the shirt to make sure that the ironing
dummy arms are not twisted.
❏ After pulling the shirtsleeves back down,
push the ironing dummy arms back into the
shirtsleeves from the cuff adjusters until the
seams between the cuffs and the sleeves
line up with the curved parts of the cuff
adjusters, Fig. 9.
Warning!
Make sure that the ironing dummy arms
are not twisted inside the shirtsleeves.
❏ Open the flaps on the cuff adjusters.
❏ Position the shirt cuffs on the cuff adjusters.
Make sure that the cuff adjusters are
aligned beneath the openings where the
two sides of the shirt cuffs join.
❏ Close the flaps. The cuff adjusters hold the
shirt cuffs firmly in position.
Short sleeves:
❏ Fit button arm straps onto the ironing
dummy arms approximately 5 cm beneath
the shirtsleeves. Figs. 10 and 11.
Warning!
Only use the button arm straps supplied by
the manufacturer. Only these straps
guarantee the air pressure required for
good ironing results.
Adjusting size
❏ If necessary, adjust the size by gradually
loosening the adjustment cords.
❏ If the adjustment cords are too tight, the
ironing dummy can be adjusted to the
garment by gradually loosening the cords.
The adjustment cords not covered by the
shirt need to be adjusted.
Use
Starting the ironing process
❏ Press the
comes on.
❏ Set the programme selector switch 4, Fig. 1
to the programme for the fabric to be
ironed. The digital screen displays the
programme selected: P- 03, P- 04 etc.
Remember that the temperature is the
same for all of the ironing cycles; drying
time is the only thing that varies.
❏ Each programme has a specific preheating
time. When this time is up, the start/stop
light starts to flash and the digital screen
displays the remaining ironing time.
❏ None of the indicator lights light up. More
than 5 minutes have passed since the
ironing programme was selected and the
shirt ironer has turned itself off.
❏ Turn the appliance back on again by
pressing the
❏ Press the start/stop button. The ironing
dummy inflates.
❏ It is not necessary to wait for the preheating
time to finish. You can press Start/Stop
when you wish. The length of the ironing
time automatically adjusts in order to give a
good result depending on the amount of
time the appliance has been allowed to
preheat for. The same cycle may, therefore,
last different lengths of time.
❏ If the adjustment cords have been
overadjusted, adapt the ironing dummy to
the size of the garment by gradually
loosening the cords.
❏ Pull the side seams on the shirt firmly
downwards, Fig. 12.
❏ Raise the sleeves and smoothen them out
in straight-lined motions from the shoulder
seam to the cuffs, Fig. 13.
❏ Position any pleats on the shirt (on the
back, yoke and cuffs), Fig. 14.
❏ Smoothen out any breast pockets or
pockets in other positions, Fig. 15.
27
button. The indicator light
button.