Siemens TJ10500 User Manual page 23

Your new appliance
Before reading these instructions for use,
unfold the page at the back of this manual
showing illustrations of the control panel and
the appliance itself.
Control panel, Fig. 1
1.- Button to unlock upper frame. To raise
and lower the upper frame.
2.- button with indicator light. To turn
the shirt press on and off.
tart/stop with indicator light. To start
3.- S
and stop/ pause the ironing airing
processes.
4.- programme selector switch. To select
the ironing and/or airing programme.
5.- Digital screen.
Shirt ironer, Fig. 2
6.- Head section unlocking clip.
7.- Collar adjuster knob.
8.- Button band adjuster.
9.- Control panel.
10.- Transportation handle.
11.- Upper head section.
12.- Collar adjuster.
13.- Collar support.
14.- Inflatable ironing dummy.
15.- Cuff adjuster.
16.- Size adjustment cords.
17.- Cable compartment.
18.- Filter cover and air filter.
19.- Characteristics plate.
20.- Wheels.
Before using your shirt ironer
Your shirt ironer is supplied fully assembled
and packed to protect it during transportation.
There is a rubber tightener stitched onto the
cover appliance which fits onto a guide on the
shirt ironer to hold the cover appliance in
place.
❏ Remove the cover appliance.
❏ Cover the shirt ironer with the cover
appliance when not in use.
Installing your shirt ironer
Warning!
The shirt ironer must be fully lowered for
transportation!
The shirt ironer is fitted with two wheels. There
is a handle on the front 10, Fig. 2 of the
appliance to help move it more easily.
Tilt the shirt ironer by lifting the handle on the
front and wheel it to the desired work location.
Work area
The work area needs to measure
approximately 2.50 m x 1.00 m.
Setting up your shirt ironer
The cable is rolled up on the cable supports
on the back of the shirt ironer, 17, Fig. 2.
Unroll the required length of cable and plug it
in.
Selecting the connection current
The Ironer can work at 10 or 16 Amps
depending on the power of the mains
electricity supply available. The appliance is
supplied in the 16-Amp version (see
characteristics plate, 19, Fig. 2). If you wish to
use the Shirt ironer at 10A, then you need to
change the connection current as follows:
23