Timed Drying - Hotpoint TCD ET 77 Instruction Booklet

Timed drying

GB
Each press reduces the time duration and number of available time options depending on the programme/material
selected.
The Timed Dry icon
The selected time remains displayed after the programme starts, but can be changed anytime you wish.
Delay and Time to End
Some programmes can have a delayed start (see Start and Programmes). Press
the , Delay button and the icon fl ashes.
Each press of the Delay button
in 1 hour increments, from:
after a couple of seconds cancels the delay.
The delay time is shown on the display next to the Delay button.
The display counts down the minutes of the delay period after the Start/Pause button
display shows
STARTS IN
You can change or cancel the delay time selected anytime if you wish.
After the Start/Pause button is pressed the Delay or Time to End is displayed in hours and minutes and counts down each
minute.
Time to End
After the delay period fi nishes, or for all the programme if delay not selected, this part of the display will show:
- the estimated time to the end of the programme, for automatic programmes
- the actual time remaining during a timed programme
When timed programmes are selected the time displayed throughout the cycle is the actual time remaining.
When Automatic programmes are selected the time displayed is an estimate of the time remaining. When the programme is
selected the display shows the time required to dry a full load. The time remaining is constantly monitored during the drying
cycle and is updated to show the best forecast.
The colons between the hours and minutes in the display fl ash to show the time is counting down.
Warnings
The second line of the display also gives warnings and
reminders: (reminders occur at the end of the programme)
END OF CYCLE, CLEAN FILTER AND EMPTY WATER BOTTLE
•
Reminder that the water container should be emptied and the fi lter
cleaned every time you use the dryer (see Maintenance).
EMPTY WATER BOTTLE
•
Indicates that the water container is full. The message will take a
few seconds to go out after replacing the empty water container;
the dryer must be running for this to happen (see The Controls).
Note: If the water container fi lls and this message is displayed,
the heat is turned off and your clothes will not dry.
10
is displayed next to the time..
advances the delay setting
to ,then
After selecting a programme that has a Timed Dry
option, press the Timed button and the display will
increment the selected time, each time you press and
release the button (see Start and Programmes).
and then
CLEAN CONDENSER, FILTER AND EMPTY WATER BOTTLE
•
This message indicates that you must clean the Heat pump
Condenser fi lter unit (see Maintenance) and will occur at intervals
depending how much you have used the dryer. When you fi nish the
next programme the message is cancelled. You must also clean the
fi lter.
is pressed. The second line of the