Grundig CUC 7305 Service Manual page 18

Allgemeiner Teil / General Section
P+
14 VHF1
- ----- ---------- -------- ---- -------
0-9 TXT
P14 403 MHz – 860 MHz
–
22
20
21 19
1 - 18
SPECIAL SETTINGS
2 Select channel position »14« with
3
Select display »VHF 1« with »
Note:
0 DEC0
To set the norm (television norm) select the »0« position with the
televison norm with the
OK i
3 = SECAM L' – norm/not suitable for GB market).
4 Select display »
– The display »Channel search« appears.
5
Start channel search by pressing
– The channel search stops at each television channel received.
– Repeat the search until the desired television channel appears on the screen.
+ Note:
i
Picture and sound can be fine-tuned by pressing
6 End channel search with »
7
Save the setting for this channel position with
– Set further television channels by repeating the procedure from step 2.
8 End setting with the »
INFORMATION
Pin assignment of the EURO-AV socket
If you want to connect an other appliance to the TV set (e.g. computer, amplifier), your specialized
2
dealer can establish a proper connection using the following connection table:
Pin Signal
11 = audio output right
1
12 = audio input right
13 = audio output left
14 = audio ground
15 = blue ground
16 = audio input left
17 = RGB blue input
18 = switching voltage
19 = green ground
10 = –
11 = RGB green input
12 = –
13 = red ground
14 = ground
15 = RGB red input
16 = RGB switching voltage
17 = video ground
18 = RGB switching voltage ground
19 = video output
20 = video input
21 = shielding/ground
_________________________________________________________________
». . « or », , «.
E E . ,
« and with ». « or »,
. ,
». « or », « button (0 = PAL/BG,
« with »F F « or »E E « and press ». .
F E
»F « or »E « and holding down until the search starts.
»F F « or »E
«.
i
»OK «.
« button.
i
________________________________________________________________
CUC 7305
« select the setting »UHF«.
»E E « button and select the
1 = SECAM L, 2 = PAL/I,
« once.
E « briefly.
GRUNDIG Service
25