Table of Contents
Advertisement
Installing your television set
Positioning the television set
10 cm
Place your TV on a solid, stable surface,
leaving a space of at least 10 cm around the
appliance.
Connections
Insert the aerial plug into the x socket
•
at the rear of the set.
If you are using an indoor aerial, reception
may be difficult in certain conditions. You
can improve reception by rotating the
aerial. If the reception remains poor, you
will need to use an external aerial.
•
Insert the mains plug into a wall socket.
Diagram may differ from the actual plug.
The keys on the TV set
The television set has 4 keys which are
located at front.
Installation
p3-7_21PT5217_5117.p65
10 cm
10 cm
3
Remote control
Insert the two R6-type batteries (supplied)
making sure that they are the right way
round.
The batteries supplied with this appliance do
not contain mercury or nickel cadmium.
If you have access to a recycling facility, please do
not discard your used batteries (if in doubt,
consult your dealer).
Switching on
To switch on the set, press the on/off key.
A red indicator means that the television is on
standby mode. Refer to the next page on 'Remote
Control keys' for the various keys that you could
use to switch on the set. An indicator light will
flash when it is receiving signal from the remote
control.
The VOLUME – + keys are used to adjust the
sound levels. The CHANNEL v ^ keys are
used to select channels.
To access or exit the main menu, press down
the VOLUME – + keys, simultaneously.
To select an item in the main menu, press the
CHANNEL v or ^ key.
To select an adjustment, press down the
VOLUME – or + key.
User manual-21PT5217_5117
07/06/04, 5:09 PM
3
Advertisement
Table of Contents
