Preparation; Things To Be Done For Energy Saving; Recommendations On The Fridge; Compartment - Beko CN160230 User Manual

4

Preparation

4.1. Things to be done for energy
saving
A
Connecting the product to electric energy
saving systems is risky as it may cause
damage on the product.
• Do not leave the doors of your product open for
a long time.
• Do not put hot food or drinks in your product.
• Do not overload the product. Cooling capacity
will fall when the air circulation inside is
hindered.
• Do not place the product in places subject to
direct sunlight. Install the product at least 30 cm
away from heat sources such as hobs, ovens,
heater cores and stoves and at least 5 cm away
from electrical ovens.
• Store your food in product in closed containers.
• You can load maximum amount of food to
the freezer compartment of the product by
removing the freezer compartment shelf of
drawer. Declared energy consumption value of
the product was determined with the freezer
compartment shelf or drawer removed and with
maximum amount of food loaded. There is no
risk in using a shelf or drawer suitable for the
shapes and sizes of the foods to be frozen.
• Thawing frozen food in fridge compartment will
both provide energy saving and preserve the
food quality.
C
The ambient temperature of the room
where you install the product should at
least be -5°C. Operating your product
under cooler conditions than this is not
recommended.
C
Inside of your product must be cleaned.
C
If two coolers are to be installed side
by side, there should be at least 4 cm
distance between them.

4.2. Recommendations on the fridge

compartment

• Do not allow the food to touch the temperature
sensor in fridge compartment. To allow the fridge
compartment keep its ideal storage temperature,
sensor must not be hindered by food.
Refrigerator / User manual
• Do not put hot food and beverages inside the
product.

4.3. Initial use

Before starting to use the product, check that all
preparations are made in accordance with the
instructions in sections "Important instructions for
safety and environment" and "Installation".
• Clean the interior of the product as
recommended in the "Maintenance and
cleaning" section. Check that inside of it is dry
before operating it.
• Plug the product into the grounded wall
outlet. When the door is opened the interior
illumination will turn on.
• Run the product without putting any food for 6
hours and do not open its door unless certainly
required.
C
You will hear a noise when the compressor
starts up. The liquids and gases sealed
within the refrigeration system may also
give rise to noise, even if the compressor is
not running and this is quite normal.
C
Front edges of the product may feel warm.
This is normal. These areas are designed
to be warm to avoid condensation.
9 /28EN