The Menu Tree - Audiolab M-ONE User Instructions

8; !Uif!Nfov
The menu enables you to customize the unit and optimize the interface with other equipment in your system.
M-ONE has 13 different menu pages. Press the MENU key on the remote control to enter menu mode, and then press
menu page, press or again to select different settings, press
enter the menu mode, rotating this knob turns through the menu pages; press the SEL knob again to enter any menu page and rotate the knob to change the setting, press the SEL knob
again to select a setting. No operation for 5 seconds will also exit menu mode automatically. The setting will not take effect if

The Menu Tree

The chart shows the menu options. The default settings are at the top.
Digital Filter DSD Bandwidth Display Brightness
Sharp Rolloff Normal High Show If Available
Digital Filter DSD Bandwidth Display Brightness
Slow Rolloff 50k Low
Digital Filter DSD Bandwidth Display Brightness
Minimum Phase 60k Off
DSD Bandwidth
70k
again to confirm the chosen setting and exit the menu mode. Pressing the SEL knob on the front panel can also
Track & Time Sampling Rate Jitter Rejection Default Input
Nominal Frequency Automatic Recall Last Input
Track & Time Sampling Rate Jitter Rejection Default Input
Do Not Show Actual Frequency Low Bandwidth COAX
Jitter Rejection Default Input
Medium Bandwidth OPT
Jitter Rejection Default Input
High Bandwidth PC USB
Default Input
BT
Default Input
USB A
Default Input
AUX 1
Default Input
AUX 2
or to turn to different menu pages, press
or the SEL knob is not pressed.
Trigger A Control Trigger B Control Balance Output Level
Enable Enable L 0.0dB R Adjustable
Trigger A Control Trigger B Control Balance Output Level
Disable Disable 3.5dB R 0dBr (2.2 Vrms)
Trigger B Control Balance Output Level
Follow Trigger A L 4.5dB +3dBr (3.1 Vrms)
Page 8
to enter any
Auto Standby Factory Reset Software Version
Never No Ver:0.0013
Auto Standby Factory Reset
20 Minutes Reset