Superior VRT4032WS Installation And Operation Instructions Manual page 14

OPTIONAL OUTSIDE AIR KIT
(MODEL AK4/AK4F)
Installation of outside air kit should be per-
formed during rough framing of fi replace due
to the nature of it's location. Outside combus-
tion air is accessed through a vented crawl
space (AK4F) or through a sidewall (AK4).
See Figure 11.
CAUTION: Combustion air
inlet ducts shall not terminate
in attic space.
Secure to Collars with Metal Tape, Screws
or Straps (Min. of 1/4" x 20" in size)
Air Inlet
Location
Must Allow
For Bushes
or Snow
Vented Crawl Space
(Check Local Codes
Before Installing in a
Vented Crawl Space)
Figure 11 - Outside Air Kit
Hood
Remove/Replace
Side Screws
Figure 13 - Hood Placement
(Model May Vary From Illustration)
INSTALLING FIREPLACE HOOD
AND SCREEN
1. For Indoor models, attach hood and front
panel assembly by snapping panel assem-
bly into fi replace opening (see Figure 12).
14
INSTALLATION
Continued
Air Inlet
Eyebrow
Vent Hood
Required for
Wall Installation
Loosen Top
Screws
SuperiorFireplaces.US.com
Hood
Figure 12 - Hood Placement
(Model May Vary From Illustration)
2. For Indoor/outdoor models, loosen screws
along the fi replace top face. Remove two
screws along fi replace face side. Slide
hood underneath screws on top and
tighten screws. Replace screws on side
of fi replace face side securing hood to the
face (see Figure 13).
3. Insert each screen rod through all rings
located at top of screen.
4. Insert fi rst rod into rear hole in left side of
fi rebox. Fasten rod to rear hole near center
of fi rebox using #10 x 3/8" Phillips screw
provided (see Figure 14).
5. Insert other rod into front hole on right
side of fi rebox and fasten using remaining
Phillips screw.
Top View of Rod Layout
Rear Hole
Front Hole
Rod
Ring
Screen
Figure 14 - Installing Fireplace Screen
(Model May Vary From Illustration)
Identifi cation
Label
Location
Screw
126709-01B