Dynamic Select Switch - Mercedes-Benz GLC Operator's Manual

Problem
Vehicles with a gasoline
engine:
The engine is not running
smoothly and is misfir-
ing.
The coolant temperature
gauge shows a value
above 248 ‡ (120 †).

DYNAMIC SELECT switch

Mercedes-AMG GLC 43 4MATIC
General information
Select the drive program using the DYNAMIC
SELECT switch.
Available drive programs:
S+ Sport Plus Particularly sporty driving
characteristics
S Sport Sporty driving characteris-
tics
C Comfort Comfortable and economi-
cal driving characteristics
E Economy Particularly economical
driving characteristics
I Individual Individual settings
Depending on the drive program selected the
following vehicle characteristics will change:
the engine management
R
the transmission management
R
the suspension
R
the steering
R
Possible causes/consequences and M Solutions
The starter motor was exposed to a thermal load that was too high.
Try to start the engine again (
X
If the engine still does not start:
Consult a qualified specialist workshop.
X
There is a malfunction in the engine electronics or in a mechanical
component of the engine management system.
Only depress the accelerator pedal slightly.
X
Otherwise, non-combusted fuel may get into the catalytic converter
and damage it.
Have the cause rectified immediately at a qualified specialist work-
X
shop.
The coolant level is too low. The coolant is too hot and the engine is no
longer being cooled sufficiently.
Stop as soon as possible and allow the engine and the coolant to
X
cool down.
Check the coolant level (
X
as you do so and add coolant if necessary.
DYNAMIC SELECT switch
page 133).
Y
page 309). Observe the warning notes
Y
the availability of the ECO start/stop function
R
climate control
R
the driver assistance systems
R
the availability of gliding mode
R
Further information for automatic drive program
characteristics ( page 144).
Y
Additionally, in drive program I you can config-
ure the respective vehicle characteristics using
the multimedia system. You can find informa-
tion about this in the Digital Operator's Manual.
Each time you start the engine with the Smart-
Key or the Start/Stop button, drive program C is
activated. For further information about starting
the engine, see ( page 133).
Y
139
Z