Installation - Whirlpool AMW 850 Installation, Quick Start

A
fter unpAcking the AppliAnce
not been damaged during transport and that the
appliance door closes properly.
i
n the event of problems
nearest After-sales Service.
MOUNTING THE APPLIANCE
f
ollow The supplieD separaTe mounTing insTrucTions
when installing the appliance.
PRIOR TO CONNECTING
c
heck ThaT The volTage
corresponds to the voltage in the home.
D
the microwave inlet protection
o noT remove
plates located on the side of the microwave
oven cavity wall. They prevent grease & food
particles from entering the microwave inlet
channels.
e
nsure The microwave
mounting.
e
nsure ThaT The appliance is noT DamageD
that the microwave oven door closes firmly
against the door support and that the internal
door seal is not damaged. Empty the microwave
oven and clean the interior with a soft, damp
cloth.
AFTER CONNECTING
T can be operated only if the
he appliance
microwave oven door is firmly closed.
T
he earThing of This appliance is compulsory
manufacturer will accept no responsibility for
injury to persons, animals or damage to objects
arising from the non-observance of this
requirement.
8

INSTALLATION

, make sure that it has
, contact the dealer or the
on the rating plate
oven cavity is empty before
. Check
. The
t
, only remove the appliance
o prevent Any dAmAge
from its polystyrene foam base at the time of
installation.
c
hildren should not perform instAllAtion operAtions
Keep children away during installation of the
appliance. Keep the packaging materials (plastic
bags, polystyrene parts, etc.) out of reach of children,
during and after the installation of the appliance.
D
this appliance if it has a damaged
o noT operaTe
mains cord, if it is not working properly, or if it
has been damaged or dropped. Do not immerse
the mains cord in water. Keep the cord away
from hot surfaces. Electrical shock, fire or other
hazards may result.
i
f The power supply corD
qualified electrician or serviceman installer an
outlet near the appliance.
T
he power supply corD
connecting the appliance, once fitting in its
housing, to the main power supply.
f
to comply with current safety
or insTallaTion
regulations, an omnipolar switch with
minimum contact gap of 3 mm must be utilized.
T are not liable for any
he manufacTurers
problems caused by the user's failure to observe
these instructions.
a , the bottom of the appliance
fTer insTallaTion
must no longer be accessible. For correct
appliance operation, do not obstruct the
minimum gap between the worktop and the
upper edge of the oven.
is too short, have a
must be long enough for
.