Table of Contents
Advertisement
Step 2/3:
Connector disassemble illustration.
To pull out wires at pin #1, #3, #7:
pull the wire tight while press
the key by using a pinset as shown.
Section 4. CONNECTING & PLAYING of
When the
is connected to the adaptor,
normal screen returns. Set source to CD changer on your radio, the audio of
back at DISC 5 and Track 1. Adjust VOLUME, BASS, TREBLE and etc. as you would normally do
for the other program sources on the radio.
Section 5. CONNECTING & PLAYING of
5-1 Connecting
After connection, the
5-2 Select
mode on VW radio
Press the CD button on radio repeatedly until "CD 6-x" appears on the radio display (x is the track
number of "Now Playing" song on
synchronized and activated. Synchronization timing varies according to the number of Playlists on
your
.
If
was playing previously before radio or ACC power was OFF, and the
playback resumes from where it was stopped.
's screen will go blank for few seconds before the
to the interface
will take a few moments to change to external control mode.
). This display confirms that
-8-
To insert the wires into pin #1, #3, #7:
raise the key up as shown,
then insert into the pin hole
in DIRECT MODE
in HYBRID MODE
mode has been completely
music will be played
was not disconnected,
Advertisement
Table of Contents
