Remove The Plug From The Socket; Connecting To The Mains - Bosch ARM 32 Original Instructions Manual

OBJ_BUCH-2138-003.book Page 11 Wednesday, January 13, 2016 2:41 PM
– Do not mow on excessively steep
slopes.
– Always be sure of your footing on
slopes or wet grass.
– Mow across the face of slopes – nev-
er up and down.
– Exercise extreme caution when
changing direction on slopes.
 Use extreme caution when stepping
back or pulling the machine towards
you.
 Never mow by pulling the mower to-
wards you.

Stop the blades if the machine has to
be tilted for transportation when
crossing surfaces other than grass
and when transporting the machine
to and from the area to be mowed.

Do not tilt the machine when starting
or switching on the motor, except if
the machine has to be tilted for start-
ing in long grass. In this case, do not
tilt it more than absolutely necessary
and tilt only the part which is away
from the operator. Always ensure
that both hands are in the operating
position before returning the ma-
chine to the ground.
 Switch on the motor according to the
instructions with feet well away from
rotating parts.
 Do not put hands or feet near or un-
der rotating parts.
 Always stand clear of the discharge
zone when operating the machine.

Never pick up or carry the machine
while the motor is running.
Bosch Power Tools
 Keep supply cables and extension
cables away from the blade. The
blade can cause damage to the cables
and lead to contact with live parts.
Beware electric shock hazard.
 Do not modify this product. Unau-
thorized modifications may impair
the safety of your product and may
result in increased noise and vibra-
tion.
 Regularly inspect the supply cable
and any extension cables. Do not con-
nect damaged cables to the supply or
touch a damaged cable before it is
disconnected from the supply. A
damaged cable can lead to contact
with live parts. Beware electric shock
hazard.

Remove the plug from the socket:

– Whenever you leave the machine.
– before clearing a blockage,
– before checking, cleaning or working
on the machine,
– after striking a foreign object. Inspect
the machine for damage and make re-
pairs as necessary,
– if the machine starts to vibrate abnor-
mally (check immediately).

Connecting to the mains

 The voltage indicated on the rating
plate must correspond to the voltage
of the power source.
 We recommend that this equipment
is only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA residu-
al current.
English | 11
F 016 L81 403 | (13.1.16)