Subaru impreza 2017 Owner's Manual page 211

. When there is a preceding or oncoming
vehicle.
. When the EyeSight system is malfunc-
tioning or is temporarily stopped.
NOTE
The factory setting (default setting) for
this function is set as operational .
This setting can be changed to OFF
(non-operation) at SUBARU dealers.
For more details, contact a SUBARU
dealer.
How to use the high beam assist
function
The high beam assist function will be
activated when all the following conditions
are met.
. The light control switch is in the
AUTO position and the low beam head-
lights are on automatically.
. The turn signal lever is pushed forward.
High beam assist indicator
When the high beam assist function is
activated, the high beam assist indicator
light (green) on the combination meter will
illuminate.
NOTE
If the high beam assist function is
malfunctioning or is temporarily
stopped, the headlight will be fixed at
low beam. For details, refer to the
Owner s Manual supplement for the
EyeSight system.
Instruments and controls/Light control switch
How to temporarily lower the sen-
sitivity of the high beam assist
function
The sensitivity of the high beam assist
function can be lowered by performing the
following operations.
1. Before turning the ignition switch to the
ON position, set the light control switch
to the AUTO position and push the signal
lever forward (high beam position).
2. Turn the ignition switch to the ON
position and within approximately 15
seconds, press the
tance setting) switch more than 10 times
consecutively.
When the sensitivity of the high beam
assist function is lowered, the high beam
assist indicator light
combination meter will flash.
NOTE
. The sensitivity of the high beam
assist function cannot be lowered in
the following conditions.
Cruise control or Adaptive Cruise
Control is in operation
The EyeSight warning indicator
(yellow) is illuminated
. The sensitivity of the high beam
assist function returns to normal level
3-69
(following dis-
(yellow) on the
CONTINUED