Extending The Arm Bracket (In); Attaching Adjusting Block (D) - Hitachi HAS-WM05 User Manual

2 Loosen the fastening screw (in the location indicated by the arrow in the
diagram below) and extend the arm bracket (IN). Attach the adjustment block
(D) to the arm bracket (IN).
Adjusting block (D)
Note:
Face the knobs of the adjustment block (D) in the
directions shown in this diagram.
3 Attach the adjustment block (D) to the arm bracket with four M4 x8mm
hex-head screws (J). Align with the projection screen size and attach to the
position as indicated in the diagram.
Tightening torque: 0.98 N•m (10 kgf•cm)
M4 × 8 hexagon head
screws (J) (Four places)
Adjusting block (D)
*Far side of arm bracket (IN)
Projection screens smaller than 70 inches
■ Assemble the adjusting block (D) according to projection screen size.
HAS-WM05
M4 × 8 hexagon head
screws (J) (Four places)
Arm bracket (IN)
CAUTION
8
Fastening screw
Arm bracket (IN)
Arm bracket (IN)
Adjusting block (D)
*Near side of arm bracket (IN)
Projection screens 70 inches or larger
4
Arm
5