Cable Box Connections - Philips 13MT1532, 13MT1533 User Manual

2
I f you cable signal uses a cable box or
decoder, follow the easy steps below to
complete the connection.
Cable Box (w/RF In/Outputs):
This connection will be mono.
1
Connect the Cable Company
supplied cable to the signal
IN(put) plug on the back of the
Cable Box.
2
Using a separate round coaxial
cable, connect one end to the
OUT(put) (TO TV) plug on
the back of the Cable Box.
3
Connect the other end of the
round coaxial cable to the 75
input on the back of the television.
Screw it down finger tight.
NOTE: If applicable, set the OUTPUT
CHANNEL SWITCH on the back of the
cable box to CH 3 or 4. Tune the TV to
the same channel and change channels
at the cable box. In some cases, the
cable box will automatically tune to
either channel 3 or 4, change channels
until the picture appears.
Helpful Hints
If no Video Signal is present, the TV
will display a "BLUE" screen and shut
itself off in about 5 minutes. If the TV
is tuned to the AV channel and there
is no Video Signal present, the screen
will remain black and the TV will shut
itself off in about 5 minutes.

Cable Box Connections

Cable Signal IN
from the Cable
Company
2 1
CABLE
IR
TO
IN
TV/VCR
USB
3
75
Round 75
Coaxial Cable
VIDEO
AUDIO IN
SPDIF IN OUT
R L
S-VIDEO
DVD-D OUT
AUDIO OUT Y Pb Pr
OPTICAL
TV
SPDIF
PASSCARD
Jack Panel Back of Cable Box
75
Jack Panel Back of TV