Table of Contents
Advertisement
2
I
f you cable signal uses a cable box or
decoder, follow the easy steps below to
complete the connection.
Cable Box (w/RF In/Outputs):
This connection will be mono.
1
Connect the Cable Company sup-
plied cable to the signal IN(put) plug
on the back of the Cable Box.
2
Using a separate round coaxial cable,
connect one end to the OUT(put)
(TO TV) plug on the back of the
Cable Box.
3
Connect the other end of the round
coaxial cable to the 75Ω input on the
back of the television. Screw it down
finger tight.
NOTE: Set the OUTPUT CHANNEL
SWITCH on the back of the cable box to
CH 3 or 4. Tune the TV to the same channel
and change channels at the cable box.
Cable Box (w/Audio/Video Outputs):
This connection will supply Stereo sound.
4
Connect the Cable Company sup-
plied cable to the cable signal
IN(put) plug on the back of the Cable
Box.
5
Using a RCA type Video Cable, con-
nect one end of the cable to the
Video (or ANT, your cable box may be
labeled differently) Out jack on the
cable box and the other end to the AV1
Video Input on the TV.
6
Connect one end of the Audio Left
and Right Cable to the left and right
Audio Out L & R jacks on the cable
box. Connect the other end to the AV1
Audio L & R Input jacks on the TV.
NOTE: Use the Channel +, or – buttons on
the TV remote control to tune to the AV1
channel for the cable box signal. Once
tuned, change channels at the cable box, not
the television.
C
B
C
ABLE
OX
Cable Signal IN
from the Cable
Company
CABLE
Round 75Ω
Coaxial Cable
Cable Signal IN
from the Cable
Company
CABLE
IN
Video Cable (Yellow)
6
ONNECTIONS
Cable Box (w/RF In/Outputs):
Output Channel Switch
1 2
TO TV
IN
Jack Panel Back of Cable Box
3
Jack Panel Back of TV
Cable Box (w/Audio/Video Outputs):
4
Cable Box with A/V Outputs
OUTPUT
CH
3
4
L
TO
VIDEO
AUDIO
TV
OUT
OUT
5
AV1
75
in
VIDEO
L
AUDIO
R
AV1
75
in
VIDEO
L
AUDIO
S-VIDEO
R
OUTPUT
CH
3
4
AV1
75
in
VIDEO
L
S-VIDEO
AUDIO
R
24
R
Audio Cables
L & R (Red, White)
Jack Panel
Back of TV
S-VIDEO
6
Advertisement
Table of Contents
