Makita UC3020A Instruction Manual page 6

･
Chain brake applied
･
Prohibited!
･
Only for EU countries
Do not dispose of electric equipment
together
material!
In observance of European Directive
2012/19/EU on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for cutting lumbers and logs.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause
voltage fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.35 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected
with a fuse or protective circuit breaker having slow
tripping characteristics.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 1 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
with household
equipment and
environmentally compatible
noise level determined
) : 89 dB(A)
pA
) : 100 dB(A)
WA
value (tri-axial vector
2
) : 3.8 m/s
h
2
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
waste
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
its
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
ENE031-1
is running idle in addition to the trigger time).
ENF002-2
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
ENF100-1
Chain Saw
Model No./ Type: UC3020A, UC3520A, UC4020A
Specifications: see "SPECIFICATIONS" table.
are of series production and
Conforms to the following European Directives:
2000/14/EC, 2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
The EC-Type Examination Certificate No.M6A 12 10
26932 045
The EC-Type
ENG905-1
2006/42/EC was performed by:
TÜV SÜD Product Service GmbH,
Ridlerstraße 65, 80339 MÜNCHEN, Germany
Identification No. 0123
The technical documentation is kept by:
Makita International Europe Ltd.
Technical Department,
Michigan Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
ENG900-1
The conformity assessment procedure required by
sum)
Directive 2000/14/EC was in Accordance with annex V.
Measured Sound Power Level: 100.0dB (A)
Guaranteed Sound Power Level: 101.0dB (A)
6
Corporation as the
Examination per
ENG901-1
ENH026-6
responsible
98/37/EC and