Redback A 2698A Instruction Manual page 6

A 2698A Digital (DAB+) Bluetooth FM Tuner
Functions:
1. MODE: Press this to switch between DAB digital
radio and FM analogue radio. It is also used to
leave Bluetooth mode.
2. MUTE: Press once to MUTE audio. Press again
to cancel MUTE and restore audio to set level.
3. STANDBY: The Standby button turns the unit into
or out of standby condition. When the unit is in
standby the LCD backlight is off and the power
LED is red.
4. 1-10 PRESET CHANNELS: Available for each of
DAB+ and FM bands. Press a number once to
select and recall that preset station memory and it
will tune in. Press and hold the numeric button to
store a tuned station to that preset number
memory. See complete steps in Presets section.
5. INFO: This changes what information is displayed
on line two of the LCD display in DAB+ and FM
and Bluetooth modes. See section on LCD
Display Information for more details.
Furthermore, by holding this button on the remote
control while in FM mode, the device will scan up
the FM frequencies..
6. AUTO:
• DAB mode: Press once for quick scan mode. Hold
for longer than two seconds to activate a full
search across entire band(s).
• FM mode: Press once to activate a 'seek' up
through FM frequencies to find the next available
station. Press and hold to activate a 'seek' down
through FM frequencies to find the next available
station.
7/8. TUN+/TUN-: In DAB Mode: Press TUN+ or
TUN- to scroll through the station list i.e. the
names of the stations.
In FM Mode: Press TUN+ or TUN- to scroll
through the frequencies (in steps of 0.05MHz).
9. ENTER: Press to confirm the selection of a DAB+
station after scrolling through the station list.
When in the MENU function, press to select the
function or control parameter. Press and hold for
two seconds to switch into Standby.
10/11. VOL+/VOL-: Adjust the volume level, louder
or softer.
6
1
4
5
7
12
14
9
15
Figure 2: Remote Control
12. BT: Press to select Bluetooth mode and make
the unit's Bluetooth module discoverable and
searching. Press again to select an already
paired device. To get back to DAB+ / FM, just
press MODE.
13. MENU: Press to gain access to function control
and parameter setting. Factory reset is
available from the SYSTEM sub-menu.
14. >||: Play/Pause button to control playback in
Bluetooth mode.
15/16. |<< & >>|: Press to skip to tracks or to tune
station frequencies.
• Bluetooth mode - these buttons allow the user to
skip back to the start of a track playing, or to the
start of the previous track, or forward to the start
of the next track.
• FM mode - Press either the left or right arrow to
tune the station frequency in either the up or down
direction. Press and hold to auto search in either
direction until the tuner can lock onto the signal of
one station.
• DAB mode - Press to scroll through the DAB
station list in either direction. Press the Enter
button to tune into that station.
2
3
10
6
8
13
16
11
®