Remote Control - Redback A 2698A Instruction Manual

®
Figure 1:
Under side of

remote control

showing battery
compartment
By using the provided remote control unit, the system can be controlled from your listening position. To use the
remote control unit, point it at the remote sensor window at the front of the receiver. Use the remote control
unit within a range of about seven meters and an angle of up to 30 degrees aiming at the remote sensor.
• Line of Site - Even if the remote control unit is operated within the effective range, remote control operation
may be impossible if there are obstacles between the unit and the remote control.
• Interference - If the remote control unit is operated near other appliances which generate infrared rays, or if
other remote control devices using infrared rays are used near the unit, it may operate incorrectly.
REMOTE CONTROL
Battery Installation:
1. Remove the battery compartment cover.
2. Insert 1x CR2025 lithium battery. Ensure the '+' and '-' are
positioned correctly.
3. Close the cover until it clicks.
Note: If the distance required between the remote control unit and main unit decreases,
the battery is exhausted. In this case, replace the battery
Precautions Concerning Batteries:
• Be sure to insert the batteries with correct positive+ and negative - polarities.
• When the remote control unit is not to be used for a long time (more than a month),
remove the batteries from the remote control unit to prevent them from leaking. If a
leak occurs, wipe away the liquid inside the battery compartment and replace the
batteries with new ones.
• Do not heat or disassemble batteries and never dispose of old batteries by throwing
them in a fire.
A 2698A Digital (DAB+) Bluetooth FM Tuner
5