Advertisement
McCulloch 32cc Trimmer
3.21. Unplug the stop switch wires from the ignition
module as the starter housing is removed from
the engine. See Figure 3.21.
Ignition module
Figure 3.21
NOTE: There are two sets of stop switch wires.
The set inside the starter housing connects to
the ignition module. The set of stop switch wires
in the clutch housing connects the set inside the
starter housing to the stop switch.
3.22. The throttle cable is best left in the starter hous-
ing as it is removed. This can be done by simply
rotating the starter housing out of the way.
See Figure 3.22.
Starter housing removed
Throttle cable
Figure 3.22
Stop switch wires
Starter housing
3.23. Alternatively, the throttle cable could be discon-
nected from the engine by squeezing the tabs,
and removing it along with the starter housing.
See Figure 3.23.
Squeeze tabs
NOTE: If a throttle cable needs replacement,
attach a line to the carburetor end of the old
cable before removal, to facilitate "fishing" the
replacement cable into place.
3.24. Remove the baffle from the starter housing using
a T-25 driver.
NOTE: The starter pulley is held in place by the
baffle. There are no other fasteners on it.
3.25. Once the baffle is removed, the starter pulley
can be carefully lifted out to access the recoil
spring. See Figure 3.25.
Stop
switch
wires
Baffle
8
Figure 3.23
Posts
Figure 3.25
Advertisement
