Table of Contents
Advertisement
Instructional Manual
CONDENSER MAINTENANCE
It is essential to keep the condenser coils clean and free of dust and debris at all times. It is required to
periodically clean the condenser coils with a soft bristle brush or vacuum-cleaner to properly
maintain the refrigeration system. Failure to clean the condenser at regular intervals
may cause failure of the refrigeration system and could void the warranty.
1
Remove the rubber cap from the front Grill.
2
Using a small Phillips head screwdriver, remove the three screws as shown.
3
The front plastic grill can now be removed by pulling it up.
4
Using plastic bristle brush, carefully clean the coil being
aware that coils can bend or be damaged if too much
force is used - shown left.
5
Replace grill and utilize the Phillips
screwdriver to tighten the screws into place,
replace the rubber caps.
MAINTENANCE - Cleaning Shutdown Questions and Answers
Cleaning and Maintenance
1
Unplug the cooler before cleaning.
2
Use a soft cloth or sponge with water or soap (non-corrosive mild detergent), while cleaning.
After cleaning, wipe the cooler using dry cloth to keep the cooler from rusting.
3
Do not spray water on the cooler, and do not use hard or steel brushes to clean the cooler.
4
Do not use organic solvents, boiling water, washing powder or acid while cleaning.
If the cooler's power will be off for a long period of time, unplug it, clean as instructed above, and keep door
open until dry.
CANOPY GRAPHICS REPLACEMENT
SETTING UP SPACER & POWER CORD HOLDERS
11
12
1
Unscrew the Graphics Holder on the Left Hand Side of the Top Canopy
2
Carefully slide out the entire Graphics piece.
3
Replace with a new Graphics piece.
4
Carefully insert and slide in the new Graphics piece.
5
Fix the Graphics Holder by fastening the screw.
The GD-14 is supplied with one set (2 pieces) of Spacers to hold the extra
length of Power Cord (shown in picture below)
1
Take out the two Spacers and screws supplied in the
Accessory Pack shipped with the Cooler.
2
Use a Philip's screw driver to fix the two Spacers at
positions as shown in picture below.
GD-14
Innovative DisplayWorks
Advertisement
Table of Contents
