Table of Contents
Summary of Contents for IDW GD-14
- Page 1 Instruction Manual GD-14 ouble everage ooler Manual is for the following models: GD-14-C13EB 990 N. Amelia Avenue, San Dimas, CA 91773 • www.idw-usa.com office 909.447.8254 • fax 909.305.8756 • toll free 877.307.2665...
-
Page 2: Table Of Contents
GD-14 FOR YOUR FUTURE REFERENCE ■ Thank you for using our product. This manual will guide you in getting the best use of your cooler. ■ Remember to record the model and serial number located on the back of the cooler. -
Page 3: Parts & Identification
GD-14 Instructional Manual PARTS & IDENTIFICATION SAFETY PRECAUTIONS When using this appliance, always follow the basic safety precautions: 13 14 1. Read the entire User’s Manual before operating this appliance. 2. Use this appliance only for its intended purpose as described in this User’s Manual. -
Page 4: Features
• This equipment is intended for storage and display of non-hazardous packaged product. IDW requires that a sole use circuit be dedicated for the unit. Failure to do so voids warranty. WARNING: Do not use extension cords. WARNING: Compressor warranties are void if compressor burns out due to low voltage. -
Page 5: Replacing The Interior Light
GD-14 Instructional Manual REPLACING THE DOOR LED LIGHTS REPLACING THE INTERIOR LIGHT Unplug the cooler. Unscrew (4) screws using a Philip’s screwdriver and remove the plastic cover. Remove light cover. Disconnect top light strand. Disconnect the lights. Disconnect middle light strand. -
Page 6: Replacing The Canopy Light
Unscrew the Graphics Holder on the Left Hand Side of the Top Canopy Temperature Adjustment • GD-14 performance testing position of the thermostat is around 3.5-5. REPAIR AND MAINTENANCE FOR REFRIGERATION DRAWER Carefully slide out the entire Graphics piece. * A CERTIFIED TECHNICIAN IS REQUIRED TO REPAIR ALL REFRIGERATION COMPONENTS FOR WARRANTY PURPOSES. -
Page 7: Condenser Maintenance
SETTING UP SPACER & POWER CORD HOLDERS Replace grill and utilize the Phillips The GD-14 is supplied with one set (2 pieces) of Spacers to hold the extra screwdriver to tighten the screws into place, length of Power Cord (shown in picture below) replace the rubber caps. -
Page 8: Troubleshooting
GD-14 Instructional Manual GD-14 CIRCUIT DIAGRAM Troubleshooting The following are not Malfunctions: Issues Solutions Liquid flowing noise within cooler This liquid is the sound of the cooling agent flowing through XP L the pipes. Refrigeration system is shutdown for This refrigerator has a strong level of heat preservation and longer periods of time while tempera- can maintain a relatively ambient temperature. - Page 9 Innovative DisplayWorks, Inc. 990 N. Amelia Avenue, San Dimas, CA 91773 toll free: 877.307.2665 office: 909.447.8254 fax: 909.305.8756 www.idw-usa.com...