Instructional Manual
FEATURES
•
Designed with an elegant shape and quick refrigeration speed, this commercial-grade product is an
ideal choice for shopping malls, supermarkets, hotels, etc.
•
Transparent glass doors are built with hollow, toughened glass that provides a high level of heat
insulation. Clear doors allow for high product visibility.
•
The forced air system allows for fast cooling speeds, which helps maintain a consistent temperature.
•
Adjustable shelves allow for a wide variety of products to be stocked.
•
The refrigeration unit is designed for easy access, allowing for fast and simple repairs.
•
This equipment is intended for storage and display of non-hazardous packaged product.
INSTRUCTIONS
Ambient Environment
•
Place cooler on an even surface to reduce vibration and noise.
•
To transport, do not tilt the cooler beyond a 45 degree angle.
•
Do not place cooler in direct sunlight or near any heat sources.
•
Do not place cooler in environment temperatures that exceed 109°F.
•
Do not place cooler in below normal temperatures.
•
Do not place cooler in extreme humid environments, this may cause components to rust.
•
Do not place cooler near constant running or splattering water, this may cause immediate damage to
refrigeration system.
•
Must allow at least 2" between rear of cooler and wall for proper ventilation and heat dissipation of
cooler.
•
Do not place furniture or other articles with sharp edges near the cooler in order to prevent damage to
the glass door.
PREPARATION PRIOR TO OPERATION
•
Remove all packaging materials before using cooler.
This includes: foam pedestal, adhesive tape (used to fix accessories) and protective gaskets.
•
Inspect cooler for concealed damage. Immediately file a claim with the freight carrier if there is damage.
IDW is not responsible for damage incurred during shipping.
•
For proper operation, place the cooler on a dry, level surface.
•
Clean the interior surface with a soft cloth and lukewarm water before operation.
•
Keep cooler in an upright position for 30 minutes prior to use.
•
IDW requires that a sole use circuit be dedicated for the unit. Failure to do so voids warranty.
WARNING: Do not use extension cords.
WARNING: Compressor warranties are void if compressor burns out due to low voltage.
WARNING: Power supply cord should not be removed or altered in any way.
Shelving Installation
5
6
•
Hook shelf clips on shelf strip.
•
Position all four shelf clips equal in distance from the
floor for flat shelves.
•
Place shelf on shelf clips.
GD-14
Innovative DisplayWorks