Energy Saving Mode - Bialetti COURE Instructions For Use Manual

EN
6. Dispensing coffee/tea/infusions
UPON FIRST START UP, IT MAY TAKE A FEW MORE SECONDS TO DISPENSE COFFEE.
THIS IS BECAUSE THE HYDRAULIC CIRCUIT, WHICH IS INITIALLY EMPTY, NEEDS TO
BE FILLED WITH THE WATER FROM THE RESERVOIR. IT IS NORMAL FOR THE COFFEE
MAKER TO VIBRATE MORE AND MAKE MORE NOISE, AS THE SYSTEM NEEDS TO START
UP COMPLETELY.
IN THE EVENT THAT THE CAPSULE INSERTION DOOR IS NOT CLOSED PROPERLY, THE
COFFEE MAKER WILL NOT DISPENSE ANY COFFEE AND WILL REPORT THE ANOMALY
WITH A BEEP. THE TOUCH-SENSITIVE BUTTON LED WILL START BLINKING RED AND
GREEN ALTERNATELY. ONCE YOU CLOSE THE DOOR, COFFEE STARTS TO BE DISPENSED
AUTOMATICALLY.
IN THE EVENT THAT CAPSULE INSERTION DOOR IS OPENED WHILE DISPENSING COF-
FEE, THE COFFEE MAKER WILL STOP AND THE TOUCH-SENSITIVE BUTTON LED WILL
START BLINKING RED AND GREEN ALTERNATELY TO INDICATE THE ERROR. THE COFFEE
WILL START OPERATING AGAIN AS SOON AS YOU CLOSE THE DOOR.
IN THE EVENT THAT THE USED CAPSULE DRAWER IS NOT INSERTED PROPERLY, THE
COFFEE MAKER WILL NOT DISPENSE ANY COFFEE. IT WILL DO SO AUTOMATICALLY AS
SOON AS YOU INSERT THE DRAWER.
THE COFFEE MAKER WILL NOT DISPENSE ANY COFFEE IN THE EVENT THAT YOU INSERT
A CAPSULE THROUGH THE DOOR WHEN THE USED CAPSULE DRAWER IS FULL. EMPTY
THE DRAWER AND START DISPENSING MANUALLY AFTER ITS REINSERTION.
IT IS THE USER WHO DECIDES THE COFFEE/INFUSION DISPENSING TIME. HOWEVER,
THERE IS A SAFETY CONTROL THAT STOPS DISPENSING AND OPENS THE UNIT AFTER
100 SECONDS OF OPERATION, CORRESPONDING TO 150 ML.
TEA AND INFUSIONS BREWING MIGHT BE LESS SMOOTH THAN COFFEE BREWING, BE-
CAUSE THEY ARE MADE OF INGREDIENTS NATURALLY RICH IN ESSENTIAL OILS WHICH
PRODUCE A LIGHT FROTH. THIS IS ABSOLUTELY NORMAL, AND DOES NOT SPOIL IN ANY
WAY THE PRODUCT QUALITY.
34

7. Energy saving mode

This appliance has been developed in compliance with EC1275/2008 e
2009/125/EC directives, which call for the energy saving mode; in stand-by
mode, power consumption is below 0.5W.
The coffee maker enters stand-by mode automatically after 10 minutes of inacti-
vity. The touch-sensitive button LED will start blinking red very slowly.
To exit stand-by mode, proceed in one of the following two ways:
• Touch the touch-sensitive button:
The coffee maker warns the user with a beep and the button starts pulsing red
during reheat period, until the machine is ready to dispense. Only then the but-
ton will return steady green and it is possible to proceed with a new brewing.
• Open the door to insert a capsule:
When you close the door, the system will move into position, however, the ma-
chine will not start dispensing until the boiler is at the right temperature; during
this stage, the touchsensitive button pulses red. When the coffee maker is ready
to dispense, the touch-sensitive button returns steady green and the system will
automatically proceed with brewing.
THE RESTART PERIOD DEPENDS ON HOW LONG THE MACHINE HAS BEEN IDLE, AND
MIGHT TAKE UP TO 30 SECONDS IT IT HAS NOT BEEN USED FOR FEW HOURS.
THE COUNTING SYSTEM WILL NOT BE RESET IN THE EVENT THAT THE USED CAPSULE
DRAWER IS REMOVED AND EMPTIED WHILE THE COFFEE MAKER IS IN STAND-BY
MODE. UPON RESTARTING THE COFFEE MAKER, IT WILL START COUNTING FROM WHE-
RE IT LEFT (IF THE COFFEE MAKER ENTERED STAND-BY MODE WITH 3 USED CAPSULES
IN THE DRAWER, THE EXPELLED CAPSULE WILL BE COUNTED AS THE FOURTH, EVEN IF
YOU HAVE EMPTIED THE DRAWER IN THE MEANTIME).
EN
35