Installation Instructions - Hafele HF-BI60A User Manual

Installation instructions

! It is recommended that this installation be performed by authorized technical stuff.
! Before installation, read the instructions carefully.
! Fit the refrigerator/freezer in stable kitchen units only.
! If necessary, reverse the door according to instructions.
1. See fig.A for the necessary attachment components.
2. Open the package. Take gasket spacer
middle part is door hang rail
3. Insert trim flap
1
4. Pass the power cord through ventilation shaft and position it so that the appliance could
be easily plugged in once it has been installed. (fig.B - fig.C)
5. Cut trim gasket
of the appliance. (fig.E)
6. Raise the appliance and slide into the kitchen unit.
7. Lean the appliance to the kitchen unit through the hinges and align the front feet with front
surface of the kitchen unit. (fig.F)
8. Open the appliance doors and screw the front feet by using screws
9. Screw trim flap
10. Screw the hinges to the kitchen unit using screws
11. Close the appliance doors. Unscrew and take out the nuts
bolts from the appliance upper door
12
12. Take out the liners of the tapes on door hang rails
appliance upper door
aligning the front surfaces of the door hang rails
door hang rails
10
13. Slide the door hang
14. Take out the liners of the tapes on the front side of the door hang
15. Take out the liners of the tapes on the unit door spacers
unit upper door
16. Lean the unit door
and top edges with the sides of the unit or the doors of the nearer and upper kitchen
units. (fig.K)
17. Make sure that the unit upper door
allowing the door hang
sticked on the unit upper door
18. Lay down the unit upper door
door by screws
15
19. To overcome some of the furniture mistakes, there are plastic spacers
door hang . Remove these plastic spacers
2
20. Remove the door hang rails
bolts to the holes on the appliance upper door
12
unit door spacer
. The other two parts are unit door spacers
10
into slot and screw by screws
to the height of the recess and stick it on reverse side of the door hinges
4
to kitchen unit using screws
1
by inserting the bosses on the holes of the appliance upper door
19
stick onto the appliance upper door
into door hang rails
2
, closer to the upper corners. (fig.K)
15
to the door hang
15
slide out the door hang rails
2
. (fig.L)
15
to the floor and screw the door hang
15
. (fig.L)
7
from the appliance upper door
10
. (fig.N)
11
and brake into three as shown in figure.D. The
9
. (fig.E)
6
. (fig.G)
7
. (fig.G)
7
. (fig.H)
19
. Place door hang rails
10
and appliance door parallel. Let the
10
. (fig.H)
19
. (fig.J – fig.K)
10
, aligning the unit door spacers
2
sticks onto the door hang
15
. Observe that the door hang
10
. (fig.M)
A
by leaving the necessary space using
19
EN - 18 -
. (fig.D)
11
. (fig.G)
7
, washers and adjustment
14 13
.
2
and and stick them onto the
11
on the left, right
11
. Pull the unit door
2
to the unit upper
2
sticked on the
A
. Screw the adjustment
19
on the
10
,
19
15
stays
2