Table of Contents
Advertisement
Available languages
Available languages
User Maintenance Instructions
This appliance requires little maintenance. It contains no user-serviceable parts. Any servicing requiring
disassembly other than cleaning must be performed by a quali ed appliance repair technician.
Care & Cleaning Instructions
CAUTION: Never immerse the motor base, plug or cord in water or any other liquid.
1. Always unplug the 2 in 1 Emulsifying Blender before cleaning.
2. Whenever possible, rinse attachments and accessories immediately after processing to make
cleanup easier.
3. Always handle blades using the blade collar.
CAUTION: Use extreme care when handling blades. Do not touch the blades with your ngers.
The blades are very sharp and can cause injury if touched.
4. If necessary, use any small nylon bristle brush to remove processed food from the blade and the
blade area.
5. For quick clean-ups, ll processing cup one-quarter full with clean warm water. Following the steps
outlined in the Operating Instructions, blend several times and rinse thoroughly.
6. Remove lip ring after use to clean.
CAUTION: Never use rough scouring pads or abrasive cleansers on any plastic or metal parts as
the surface may be damaged.
7. Blade, cup, jar and lip ring are top-rack ONLY dishwasher safe.
IMPORTANT: After dishwashing, always check to make sure the gasket seal in the base of the blade
collar is properly in place, as the heat from some dishwashers may cause them to become loose.
8. The motor base may be wiped with a damp cloth or sponge. Dry thoroughly.
WARNING: DO NOT IMMERSE THE MOTOR BASE IN WATER.
Storage Instructions
1. Unplug and clean unit.
2. Store in original box or in a clean, dry place.
3. Never store the 2 in 1 Emulsifying Blender while it is hot or plugged in.
4. Never wrap cord tightly around the appliance. Never place any stress on cord, especially where the
cord enters the unit, as this could cause the cord to fray and break.
Gasket Ring Replacement
•
If the gasket ring breaks or visibly deteriorates, remove the old gasket ring from the base of either
the blending or grinding blade of your blender.
•
Remove the replacement gasket ring from the bag and wash it with warm soapy water, then pat it
dry. Make sure the seal ring is completely dry before replacing it.
•
Make sure that the at surface of the replacement gasket ring is facing downward; while the
rounded side of the replacement seal is facing upwards (see Figure 5).
•
WARNING: Be careful to not touch the blades. Press the seal ring rmly into place, until it is
properly installed into the base of either the blending blade.
Figure 5
Gasket ring
Flat side needs to face the bottom
SO-313506_14588_BELLA 2in1 Blender IM_R4.indd 7
7
2016-06-06 11:18 AM
Advertisement
Table of Contents
