Philips 300WN5 Manual page 67

Troubleshooting
No Video
Low Quality DVD
playback
No sound
Remote Control Problems
Remote control does
not work properly
Product Specific Problems
Screen image is too
small
file:///D|/My%20Documents/dfu/300WN5/english/300wn5/SAFETY/saf_troub.htm (5 of 8)2005-02-16 10:33:32 AM
No signal indicator
is displayed.
Picture not crisp
and some color
distortion
See video but no
audio
No response from
the LCD Monitor
TV when remote
is pressed
Image is centered
on screen, but
does not fill entire
viewing area
Check Video Input Selection
Composite: Yellow colored RCA jack
S-Video: Typically a round 4 pin jack
Component: Typically 3 RCA jacks of
Green, Red and Blue.
Make sure you did not plug the video cable to
video output port behind the LCD monitor TV.
Check DVD connection
Composite gives good picture
S-Video gives better picture
Component gives best picture
Check if the LCD Monitor TV volume is turn
off of muted.
Connect the audio cable securely.
Audio cable is connected incorrectly.
Verify that the audio source is selected
correctly in the OSD.
Point the remote control directly at the remote
sensor on the LCD Monitor TV.
Replace both batteries with new ones.
Make sure the remote control is not disabled
(for disable/enable the remote control, please
refer to the section of
Perform the LCD Monitor TV factory reset (via
Menu -> Factory Reset -> All Settings).
Remote Control).