Sharp AQUOS Operation Manual page 12

>>
Introduction
<<
Initial Installation (Continue)
Power Saving
Select "Yes" or "No" to configure default Display settings.
2 Press / to select "Yes" or "No".
Press ENTER to enter the setting.
Yes: AV MODE is set to "STANDARD" and Automatically
Light Sensor is set to "On".
No: AV MODE is set to "DYNAMIC (Fixed)" and
Automatically Light Sensor is set to "Off". Picture Reset
can be set.
Picture Reset: AV MODE will be set to "DYNAMIC (Fixed)"
regardless of whether Picture Reset is "On" or "Off".
If you select "On" and there is no operation for 30 minutes:
- AV MODE will be reset to "DYNAMIC (Fixed)".
When "Off" is selected:
- Even after 30 minutes elapses, AV MODE is not reset to
"DYNAMIC (Fixed)".
ENG 2-3
Antenna & Cable/STB
Select the type of connection you will use to watch TV.
3 Press / to select "Antenna & Cable" or "Set-top box", and
then press ENTER.
To watch TV via an antenna or cable connection (without
using a set-top box):
Select "Antenna & Cable", and then go to step 4. To
watch TV via set-top box:
Select "Set-top box" and then press ENTER.
Check that the set-top box connected to the TV is on.