Dismantling Instructions - Philips LX7500R Service Manual

DISMANTLING INSTRUCTIONS

Dismantling the Top Cover
• Remove 9 screws as shown in picture 1.
• Release side walls on bottom and raise top cover
upwards.
Details of correct Wire Routing
To fulfil safety requirements cables must not touch the large cooling
plate (high potential) of the Switched Mode Power Supply.
After repair it has therefore to be made sure that all cables are fixed
according the instructions shown in pictures 2 and 3.
!
CABLE TIE MAINS CORD
!
FIXATION OF CABLES
8004, 8012, 8016
!
picture 1
FIXATION OF CABLES
picture 2
FIXATION CABLE 8041IN CATCH OF AIRGUIDE FOIL
picture 3
Dismantling Instructions
Manual Opening the Tray
In case the loader is defect or cannot be opened electrically, proceed
as follows:
• The tray can be released by means of screwdriver.
The locking slider of the tray can be accessed through a slot on
the bottom side of the set. To prevent dust coming into the drive
this slot is covered by an adhesive tape on the cabinet of the drive
(see picture 4).
Push through this adhesive tape and move the white pin of the
slider to the left side (see picture 5). The tray will move out a bit
and is now released.
• Pull the tray out.
Make sure that a new adhesive tape has been applied to the
drive when the repair is finished!
!
8012, 8016
Dismantling the Tray Cover
To dismantle the ornamental cover the tray has to be moved out first.
This can either be done by actuating the Open/Close key or
manually. To release the tray manually proceed as described above.
Take the ornamental cover on the bottom side and press it upwards
while supporting the tray. The cover will automatically be tilted a bit.
In turn the catches become released.
LX7500R 4.
picture 4
picture 5
picture 6
EN 15