Meccanica Benassi DAYTONA 2W User Manual page 26

(13) TRAVEL DIRECTION LEVER
It controls the power supplied to the rear wheels and regulates the speed of the machine in both directions.
In the basic setting it is equipped with a mechanical cruise control function, which is automatically
deactivated by pressing the brake pedal.
Changing the travel direction from forward to reverse or from reverse to forward is
only possible after stopping the machine. When the brake pedal is stepped on the
gear stick automatically shifts to position „N".
(14) CHOKE
For starting a cold engine:
(15) BY-PASS LEVER – FREE MOVEMENT OF THE REAR WHEELS
The by-pass lever serves to disengage the transmission for the rear wheel drive and is used to push or
pull the machine without using the engine. The lever is located on the rear side of the machine and has
the following two positions:
ATTENTION! On the 4x4 machine the lever is used primarily for bleeding the
hydrostatic system. Due to the high demands on equipment, have this procedure performed
by a specialised service centre.
The machine must not be used (gear shifted into drive) if the by-pass lever is in the disengaged
position - there is a danger of damage to the transmissions!
Moving the lever closer to the letter F corresponds to
Forward
F
travel a higher speed and vice versa
N
Neutral The machine is still
Moving the lever closer to the letter R corresponds to
Reverse
R
travel a higher speed and vice versa
CHOKE
Position Rear wheel drive
(0)
DISENGAGED
(1)
ENGAGED
Starting a cold engine
Lever is extended - for pushing the
machine
Lever is inserted - for driving the
machine
26
Use